Copy a Rule Within or Across ASA Access Lists and Devices

You can copy an access control rule in the following ways:

Within the same access list.
From one access list to another, either within the same ASA device or across different ASA devices.

Note	The paste operation fails if you attempt to add a rule that already exists in the access list.

Procedure

Step 1

In the left pane, click Security Devices.

Step 2

Click the ASA tab and select an ASA device by checking the corresponding check box.

Step 3

In the Management pane on the right, click Policy.

Step 4

From the Selected Access List drop-down list, select an access list that you want.

Step 5

Select a rule by clicking the corresponding check box and in the Actions pane on the right, click Copy.

Step 6

Perform the following:

To paste the rule within the same access list, hover the mouse pointer in the desired position until you see the Paste Rule Here option and click it. The Add/Edit rule dialog box is displayed, allowing you to modify the copied rule, as identical rules are not permitted in the same access list.
To paste the rule within the same ASA device, from the Selected Access List drop-down list, select an access list you want.
To paste the rule to a different ASA device, in the left pane, go to Security Devices > select an ASA device > Policy > Selected Access List.

Step 7

To paste the copied rule in the desired position, select a rule that comes after where you want the new rule to be. In the Actions pane on the right, click Paste. The copied rule will be inserted before the selected rule.

You can use the Move Up and Move Down buttons to position the rule as needed.

Note	Alternatively, you can hover over a desired position in the rule listing table until you see Paste Rule Here, and then click it.