Create a custom fingerprint for clients
Client fingerprints identify the operating system by analyzing the SYN packet a host sends when it connects to a TCP application on another network host.
If the Cloud-Delivered Firewall Management Center does not have direct contact with monitored hosts, you can specify a device that is managed by the Cloud-Delivered Firewall Management Center and is closest to the host you intend to fingerprint when specifying client fingerprint properties.
Before you begin
Before you begin the fingerprinting process, obtain these details about the host you want to fingerprint:
-
The number of network hops between the host and the Cloud-Delivered Firewall Management Center or the device you use to obtain the fingerprint. (Cisco strongly recommends that you directly connect the Cloud-Delivered Firewall Management Center or the device to the same subnet that the host is connected to.)
-
The network interface (on the Cloud-Delivered Firewall Management Center or the device) that is connected to the network where the host resides.
-
The actual operating system vendor, product, and version of the host.
-
Access to the host in order to generate client traffic.
Procedure
Step 1 | Choose . | ||||||||
Step 2 | Click Custom Operating Systems, and then click Create Custom Fingerprint. | ||||||||
Step 3 | Enter these details:
Example:Example: | ||||||||
Step 4 | Click Create. The status briefly shows | ||||||||
Step 5 | Using the IP address you specified as the target IP address, access the host you are trying to fingerprint and initiate a TCP connection to the appliance. To create an accurate fingerprint, traffic must be seen by the appliance collecting the fingerprint. If you are connected through a switch, traffic to a system other than the appliance may not be seen by the system. Example:
|