Create a custom fingerprint for servers
Server fingerprints identify operating systems based on the SYN-ACK packet that the host uses to respond to an incoming connection to a running TCP application.
Before you begin, you should obtain this information about the host you want to fingerprint:
-
The number of network hops between the host and the appliance you use to obtain the fingerprint. Cisco strongly recommends that you directly connect an unused interface on the appliance to the same subnet that the host is connected to.
-
The network interface (on the appliance) that is connected to the network where the host resides.
-
The actual operating system vendor, product, and version of the host.
-
An IP address that is not currently in use and is authorized on the network where the host is located.
Tip | If the Cloud-Delivered Firewall Management Center does not have direct contact with monitored hosts, you can specify a managed device that is closest to the host you intend to fingerprint when specifying server fingerprint properties. |
Procedure
Step 1 | Choose . | ||||||
Step 2 | Click Custom Operating Systems and then, click Create Custom Fingerprint. | ||||||
Step 3 |
| ||||||
Step 4 | In the OS Vulnerability Mappings section, choose the operating system, product, and versions you want to use for vulnerability mapping. You must specify a Vendor and Product name in this section if you want to use the fingerprint to identify vulnerabilities for matching hosts or if you do not assign custom operating system display information. To map vulnerabilities for all versions of an operating system, specify only the vendor and product name.
Example:Example: | ||||||
Step 5 | Click Create. The Custom Fingerprint status page refreshes every ten seconds and should reload with a "Ready" status.
|