Verify multicast routing over an SVTI tunnel
The table lists the commands to verify multicast routing over an SVTI tunnel.
|
CLI Command |
Description |
|---|---|
|
show running-config pim |
Displays all PIM configurations including IP address of the RP and BSR configurations. |
|
show mroute |
Displays the IPv4 multicast routing table to verify multicast traffic forwarding. |
|
show pim neighbor |
Displays details of the directly connected PIM neighbors. |
|
show pim tunnel detail |
Displays information about the PIM tunnel interfaces. |
|
show pim group-map |
Displays the mapping between RPs and multicast groups. |
|
show pim topology |
Displays details of the PIM topology. |
|
show pim traffic |
Displays PIM traffic counters. |
|
show pim interface |
Displays information about PIM interfaces. |
|
show igmp interface |
Displays multicast information for an interface. |
|
show mfib count |
Displays the Multicast Forwarding Information Base (MFIB) count and packet statistics. |
|
show mfib route |
Displays the MFIB routing table. |
|
show pim group-map |
Displays the multicast group to RP mapping. |