Add model mapping

Model mapping allows you to map a template to one or more models as long as the interface configurations are valid for all mapped models.

For each model, you can specify which template interface corresponds with which model interface. For example, if the template includes switch ports and VLAN interfaces, then that template can only be applied to a Firepower 1010 or Secure Firewall 1210/1220.

Follow these steps to add model mapping:

Procedure

Step 1

Choose Devices > Template Management.

Step 2

Click Add Model Mapping for the template in which you want to create the model mapping. Alternatively, you can click the Edit ( edit icon ) icon of the template and choose Template Settings > Model Mapping.

Step 3

Click Add Model Mapping.

Step 4

Choose the Device Model from the drop-down list.

Step 5

Map the template interfaces to the device model interfaces by choosing the interface from the Model Interface drop-down list.

Note	You can click Clear Mapping to remove the defined model mapping. Click Reset Mappings for default interface mapping in which the mapping is done based on the slot and port index order of the interface names.

Step 6

Click Save. The interface mappings are listed along with the device model and mapping status on the Model Mapping window.

Note	Some configurations in the template may not be supported on all device models. Unsupported configurations, if any, are not applied to the device. The device Template Apply Report provides details about such configurations.