Configure EIGRP Interfaces Settings
You can configure interface-specific EIGRP routing properties in the Interfaces tab.
Procedure
Step 1 | On the EIGRP page, click the Interfaces tab. |
Step 2 | Click Add (). |
Step 3 | From the Interface drop-down, choose the name of the interface to which the configuration applies. |
Step 4 | In the Hello Interval field, enter the interval, in seconds, between EIGRP hello packets that are sent on an interface. Valid values range from 1 to 65535. The default value is 5 seconds. |
Step 5 | In the Hold Time field, enter the hold time that is advertised by the device in EIGRP hello packets. Valid values range from 3 to 65535. The default value is 15 seconds. |
Step 6 | To enable EIGRP split-horizon on the interface, click the Split Horizon check box. |
Step 7 | In the Delay Time field, enter the delay time in tens of microseconds. Valid values are from 1 to 16777215. This option is not supported for devices in multi-context mode. |
Step 8 | Specify values for the Authentication properties:
|
Step 9 | Click Ok and Save the settings. |